This is what we see as the standard Panhard / Trackbar Bracket. It has three mounting position options, 5.5", 6'5", and 7.5" from axle center. They are cut to a 3" axle tube radius so they can be made to fit any tube diameter and made from 1/4" plate and bent perfectly, so you don't have to play with the grinder to make them fit! They have a reinforcement plate to weld in, after you determine the correct height for your rig......if it ends up to be the low hole just cut off the excess. These are setup for a 2" ID so just about any heim will fit with minimal missalignment. 9/16" holes.

For mounting a Panhard to either the front or rear axle, there are six options for Panhard height adjustment on each setup. On front axle setups.... 70-80% of the vehicles need to offset the Panhard to the forward edge of the axle for clearance, so alot of time was spent developing the ideal mounting bracket. The Centered Bracket is for those of you that can get away with it. For the frame end, the general rule of thumb is, if you have a stock width axle.... you inboard the bracket and if you are fullwidth you go outboard.