This bracket is for those of you running ~stock width axles..... it mounts on the inside of the frame and is made of 1/4" plate and bent where needed with perfectly aligned holes! It has a reinforcement plate that is added, after welding it to the frame for additional strength. It has two mounting positions so it can be fine tuned to the axle end. The drop from the frame is 2" and 3 1/4" so you can combine this with the Axle End Panhard / Trackbar Bracket for six different mounting position options! This also has a 2" ID.

For mounting a Panhard to either the front or rear axle, there are six options for Panhard height adjustment on each setup. On front axle setups.... 70-80% of the vehicles need to offset the Panhard to the forward edge of the axle for clearance, so alot of time was spent developing the ideal mounting bracket. There is a Centered Bracket for those of you that can get away with it. For the frame end, the general rule of thumb is, if you have a stock width axle.... you inboard the bracket and if you are fullwidth you go outboard.