Seems like 3 out of 4 Offset Panhard / Trackbar Brackets need to be on the leading edge of the axle for clearance issues. It has three mounting position options, 5.5", 6'5", and 7.5" from axle center. It is cut to a 3" axle tube radius, so it can be made to fit any tube diameter and it is made from 1/4" plate and bent perfectly.... so you don't have to play with the grinder to make it fit! It has a reinforcement plate, also cut to the axle bias with two drain holes built in. If it ends up that the the low hole is what you need, just cut off the excess. It is setup for a 2" ID so just about any heim will fit with minimal missalignment. 9/16" holes.

For mounting a Panhard to either the front or rear axle, there are six options for Panhard height adjustment on each setup. On front axle setups.... 70-80% of the vehicles need to offset the Panhard to the forward edge of the axle for clearance, so alot of time was spent developing the ideal mounting bracket. There is a Centered Bracket for those of you that can get away with it. For the frame end, the general rule of thumb is, if you have a stock width axle.... you inboard the bracket and if you are fullwidth you go outboard.